Vector Sync Harness Pinout

Up to General comments

Vector Sync Harness Pinout

Posted by Corey Crisp at Thursday 20:54

Hi,

We just purchased and installed one of the Sync Harnesses for the Vector to replace our Analog Output harness. What is the pinout for the DB9 connector on with the Sync Harness?

P1: Power GND?
P2: Power +?
P3: RS232 Tx?
P4: RS232 Rx?
P5: GND?
P6: ?
P7: ?
P8: ?
P9: ?

 

Thanks!

Corey Crisp

Re: Vector Sync Harness Pinout

Posted by Corey Crisp at Thursday 20:56

Or even a listing of wire harness colors to wire purpose would be great since not all wires go to the DB9 connector.

Thanks!

Re: Vector Sync Harness Pinout

Posted by Elin Bondevik at Tuesday 12:48
Hi Corey,
 
The RS232 and RS422 harnesses differs, so please find the pin outs relevant below. If you are unsure, you are welcome to send a picture of the harness to support@nortek.no and we'll send you a drawing
 
RS232:
P1 (Brown) GND
P2 (White) 232 Tx
P3 (Yellow) Pwr
P4 (Blue) Gnd
P5 (Green) 232 Rx
P6 (Orange) Sync out
P7 NA 
P8 (Purple) Sync in
P9 NA
 
RS422
P1 (Brown) GND
P2 (White) 422 Tx+
P3 (Yellow) Pwr
P4 (Blue)  Sync out 
P5 (Green) 422 Tx-
P6 (Purple) 422 Rx+
P7 (Grey) 422 Rx+
P8 (Orange) Sync in
P9 NA
 
Best regards
Elin
Powered by Ploneboard
Log in


Forgot your password?
New user?